Significantly reduces saw noise, dust, chip-out, and splintering
Constructed of high-density phenolic laminate with a bonded-melamine surface
User-friendly with leveling and lateral adjustment screws, rear anti-life pin, and precut blade bottom pocket
Editorial Review:
Leecraft zero clearance table saw inserts are precision machined from melamine faced high density phenolic laminate for outstanding durability and wear resistance. They maintain exceptional flatness, unlike wood or plastic inserts, and cut easily with carbide blades. The melamine surface provides nearly frictionless sliding and is highly impact and abrasion resistant. Each insert has top accessible leveling screws, side and end adjustment screws to facilitate perfect fit and a rear safety pin provides lift out protection. A precut starter pocket makes cutting the clearance slot easily and a finger hole makes for simple removal and hanging. Colors may vary. Made in USA.
The Leecraft Zero-Clearance Table Saw Insert for DeWalt DW744 and DW746 offers superior rigidity, flatness, durability, and low friction. This product is user-friendly with top-accessible leveling screws, lateral adjustment screws for a vibration-free fit, a rear anti-life pin, and a precut blade bottom pocket. It significantly reduces saw noise and dust, as well as chip-out and splintering. This saw insert is constructed of high-density phenolic laminate with a bonded-melamine surface to ensure a long life. It fits eWalt DW744 and DW746; instructions are included and the kerf serves as a handy stock alignment guide. This product measures 13-5/8-by-3-3/4-by-1/2-inch (length by width by thickness).
Customer Reviews:
Avg. Customer Rating: 4.5 / 5.0
Leecraft DW-2 Zero-Clearance Table Saw insert for DeWalt Model DW744 and DW746:
this Table saw inset is very heavy and well fitting. It prevents dust and debris from coming back in your face. Leecraft DW-2 Zero-Clearance Table Saw Insert for DeWalt Model DW744 and DW746
Works well....:
Nice insert. Well worth the money. Pros
- Laminate is very flat and stiff (not like the typical warped OEM castings).
- Leveling screws are at just the right positions, very tight (don't move once set).
- Has side-to-side and front-to-back set screws to tighten insert in the hole
- Orange color is nice warning to keep fingers away from danger area. Doesn't match the "Dewalt Yellow", but contrasting color is a better warning reminder.
- Detailed instructions are written... more info
Funny to be so excited about a ZCI...:
I just picked one of these up and gave it a few spins around the shop. This is really a nice product - can't believe I waited so long to get it. First of all, it is MUCH easier to adjust than the factory insert. This insert has four height adjustment screws so you can get it dead-flat with the tabletop. It also has two side screws -- one on the right side and one on the front. This allows you to tighten the insert in the throat so there's absolutely no slop. The insert stays rock-solid in place. I... more info
I could not be more pleased with this product!:
I bought this insert to use in my DeWalt 746 tablesaw and have found it to be a very high quality accessory. When my insert plate arrived I was pleased to note that it was dead flat! Installation was very easy - using the four leveling screws I was able to bring this insert perfectly level with my saw table all the way around. Once adjusted, the side-to-side and front-to-back adjustment screws took all of the play out of this insert. I also appreciate the smooth surface which allows my stock to glide across... more info
