Features:

• Versatile Y-branch for branching off main lines
• Allows you to gradually split the main line more efficiently than a T-branch
• Can also be used as a clean-out
• Slightly undersized to fit inside the hose

Editorial Review:

The Jet 4-Inch Y-Fitting Dust Hose Connector is designed for attaching branch lines to service more than one machine. The featured Y-branch design provides increased lateral airflow and efficiency when compared to traditional T-branches. The 4-inch diameter fitting can also be used as a clean-out, and is slightly undersized to fit inside the hose.

Customer Reviews:

Avg. Customer Rating: 5.0 / 5.0

Y Dust Hose Connector:

This product is as described! Connected two tubes and made into one tube!! Used as a two tube converter to a one tube converter.

Great DC fitting!:

Like all of my Jet dust collector fittings, I have been very pleased with the performance of this "Y" fitting, and it was much MUCH cheaper at my local Menards. I used these Y's in my main duct to create branches for my stationary tools on the long wall of my shop. The 4" size was perfectly consistent and always fit the ducting and flex hose without any trouble. The "Y" design greatly reduces any loss of air flow as compared to elbow fittings and the plastic is very strong and rigid.
Highly recommended... more info

Does a Great Job:

When installing a dust collection system, eliminating resistance to airflow is what it is all about. The ideal is as large a pipe as possible, flowing in a straight line, without any ridges in the surface. Of course in the real world at least some of these things wind up being less than ideal. What this Jet 4" Y-connector does, is give you a large pipe, that makes a gradual Y as opposed to a straight 90 degree angle T, and the sides of the connector are smooth. So when you need to divide your air source... more info

A Strong Link in the DC Chain:

This is a good connector for a DC system. Not a complicated piece, but a very good one. The ends were all 4" , the hose fit snuggly and the wire clamps held.

When making a branch in the DC system, to go to several different pieces of equipment, the "Y" connection is better to use than the "T". The Y will allow for a better air flow. Combine the Y with a/several blast gates, then it's almost like having a single hose go to each piece of equipment.

Accessories:

[no image] This Old House (1-year) (Magazine)

Building Construction Illustrated by Francis D. K. Ching (Paperback) - Usually ships in 1 to 3 weeks

Similar Products:

Jet JW1044 4-Inch to 2-1/2-Inch Reducer from JET (Tools & Hardware) - Usually ships in 24 hours

Jet JW1007 4-Inch Blastgate from JET (Tools & Hardware) - Usually ships in 24 hours

JET JW1317 4" Wire Hose Clamp - Each from JET (Tools & Hardware) - Usually ships in 24 hours

Jet JW1031 4-Inch x 10-Foot Black Dust Collection Hose from JET (Tools & Hardware) - Usually ships in 24 hours

Jet JW1047 4-Inch Quick Disconnect from JET (Tools & Hardware) - Usually ships in 24 hours

Jet JW1038 4-Inch Quick Disconnect with Smooth End from JET (Tools & Hardware) - Usually ships in 24 hours

Jet JW1003 4" x 21" Dust Collection Floor Sweep from JET (Tools & Hardware) - Usually ships in 24 hours

Jet JW1019 4-Inch Splice from JET (Tools & Hardware) - Usually ships in 24 hours

PSI Woodworking D50A 4-Inch x 50 Flexible Dust Collection Hose from PSI Woodworking (Tools & Hardware) - Usually ships in 24 hours

Also visit Main Street Tool & Supply Co.

Sponsor Results: