Features:

• Holds four 3rd Hands plus your 3rd Hand accessories
• Heavy-duty canvas construction

Customer Reviews:

Avg. Customer Rating: 3.0 / 5.0

Suggested improvement.:

The product works but could be improved if they added a large pocket on the inside to hold the accesories.

FastCap 3rd Hand Carry Bag:

I purchased this bag to carry my poles for my laser level and it works well for this purpose.
The bag is well made with a two zippers that allow you to open the bag almost all of the way down one side for easy access and roomy enough for the intended job.
My only suggestion/complaint is that there is no shoulder strap, which would make carrying the bag easier.
It does have a pair of loop handles at the center of the bag.

Good Idea Poor Design:

There should have been side pockets for the tops and bottoms that snap on to the posts. It is nice to have somthing to put the 3rd hands in but the bag is to big. A molded case would be ideal.

Tight squeeze:

They were too skimpy when they sized this bag. I was careful to fully retract both ends of the poles. The first pole just fit, but by the fourth pole I almost ripped the bag fitting it in. Nice idea, but an extra few inches would be much better.

Similar Products:

FastCap 3rd Hand Support System 57-to-144-Inches, 2-pack #3HAND5 from Laserjamb (Tools & Hardware) - Usually ships in 24 hours

FastCap 3HUNIFOOT 3rd Hand Universal Foot (2 pack) from Fastcap (Tools & Hardware) - Usually ships in 24 hours

FastCap Little Hand HD 3rd Hand Support System 16.5-Inch to 22.8-Inch, 2-pack from Laserjamb (Tools & Hardware) - Usually ships in 2 to 4 weeks

FastCap Accuscribe Scribing Tool from Fastcap (Tools & Hardware) - Usually ships in 24 hours

Bench Dog 10-016 Trim-Loc Casement Trim Installation Tool from Bench Dog (Tools & Hardware) - Usually ships in 24 hours

Fastcap 3HANDCPACK 3rd Hand Contractor Poles, 4-Pack from Fastcap (Tools & Hardware) - Usually ships in 24 hours

FastCap 3HLASERMNT Lasermount for 3rd Hand from Fastcap (Tools & Hardware) - Usually ships in 2 to 4 weeks

Skil 3100-12 Skil X-Bench Workstation from Skil (Tools & Hardware) - Usually ships in 24 hours

Alden Grabit Broken Bolt and Damaged Screw Extractors, 4-Piece Set from Alden (Tools & Hardware) - Usually ships in 24 hours

Also visit Main Street Tool & Supply Co.

Sponsor Results: