Customer Review: This product sucks. plain and simple. I used it once and the drill bit turned loose after 10 seconds. then I tried to reinsert, but after opening it up it got stuck on open and would not close any more. at the store they said the spring probably broke. This is after one usage. Makita is overrated... more info
Customer Review: I think everyone should own a ultralok set,! This set is pretty convenient for small jobs, because you don't have to carry around a huge case to every job. It fits allot of bits from My 200 bit set, so if you need to take additional pieces from your bigger set, or swap any pieces in the Makita set... more info
Customer Review: I've gone through a few of these lately looking for one with a good magnet. I install car radios and dropping screws is such a pain and time waster. My Black and Decker tip holder and my Dewalt tip holder don't do a very good job, and the sleeves tend to slip down a lot. I got these and the magnet... more info
Customer Review: I have stocked up on alot of the makita brand hex shank line.
The bits have the best metalurgy period. The best hex shank drill bits and driver bits are the u.s.a made makita line. Try the #2 bits and you will see what I am so happy about. The drill bit set runs great in my 1/4 inch impact... more info
Customer Review: I've been using this set in my workshop, mostly for drilling & sinking screws for drawer slides, hinges, etc. Like any other tool it needs to be handled with a certain amount of care and as other reviews note, the stud that mounts in the drill chuck is aluminum, not steel. I can imagine that... more info
