Customer Review: I use this with a 3/4 HP Porter Cable AP300 Dust Collector.
That model of dust collector is rated at 500 CFM, which is used
with a trash can lid collector. Most of the time, I work with red oak, white oak, and occasionally
hard maple. With those species, it usually works ok.... more info
Customer Review: The machine does its job and does it well. You need ear plugs and a dust collection system is absolutely essential. I found the feed system to be just a bit difficult especially as you get to smaller sizes. If you are not careful you can get a gouge on the initial entry. Snipe is not a real problem... more info
Customer Review: This adapter works great for what it is designed for. It is only for changing 4 inch hose to 2 1/2 hose. Not designed to connect directly to a tool or shop vacuums. Usually the 2 1/2 inch hose will connect to the tool.
Customer Review: Don't skimp on blades . . . just buy these. Thy are perfectly matched in the set (my caliper confirmed that, see below), they will fit the models listed, and maybe some more, and they are only a few dollars more than the 'F' brand knockoffs. I measured mine when new for those that may be unsure... more info
Customer Review: Received in three days. Well packed, great price, easy assembly, solid stand. As others have mentioned, the written instructions are poor but looking at the graphics clears any issues. I agree with the review that the foot peddle should be placed on the outside. You just can't reach it with your... more info
Customer Review: This DC is great machine for a small shop. Setup was easier then I expected. It does take an extra set of hands to setup. I have used it with my planer and bandsaw and what a difference. I should have done this sooner. The only negative is the specs say the machine runs on 110 or 220. What they... more info
Customer Review: I was let down by these jointer knives for two reasons: 1) There is a healthy burr on them which required honing, 2) worse yet the blades have a bow in them, which then require firm pressure to the honing plate to knock down the burr. Otherwise only the ends of the blade back would get cleaned up.... more info
Customer Review: I have about 15 table saw blades from Freud, Dewalt, Oldham, Rigid, you name it. All of them under 100 dollars. I just didn't think that a 100 dollar saw blade could make such a big difference. I mean how can one company make a saw blade that is THAT much better, I thought. It does!! They can! I was... more info
