CMT glass panel door set

Make glass panel doors easily!

This unique rail and stile set allows you to create glass panel doors with a rubber retainer that secures the glass in a 1/8" slot in the door frame. Set includes a 1/8" slot cutter with bearing and a matched pair of ogee rail and stile bits. 1/2" shank.

Use with router tables only! Plastic Panel Retainers also available. Use Groove type, 25 foot length.

If you are not 100% satisfied with these bits, send them back for a refund.

Router Safety Tips: It's easy to prevent mishaps if you take a few simple precautions. 1) Rockler recommends using 1/2" shank router bits whenever possible. 1/2" shanks provide better stability with less vibration to produce a smoother cut and longer cutter life. 2) Make multiple light passes rather than one heavy cut. 3) Install your router bit so that 90% of the shank is inside the collet. Here's a rule of thumb: fully insert the bit, then pull it back 1/16 to 1/8 of an inch. 4) Use a router table whenever possible. 5) When using large diameter bits, reduce the RPM of your router. Then test your set-up on scrap lumber. 6) Always follow your router manufacturer's recommendations.